Search: Posts Made By: bill1925
Showing results 1 to 25 of 189
Search took 0.02 seconds.
Replies: 3
Views: 155
Posted By bill1925

Dashboard lights on. brakes plus ABS on

The info is saying to check the wheel sensor. Where or what is that??
2001 Dodge Caravan sport
Dashboard lights on. brakes plus ABS on
Brakes work fine.
Can you check wheel SFNSONS
Replies: 1
Views: 91
Posted By bill1925

An automatic damper on a gas log fireplace

I have a wood-burning fireplace with a heatilator. It is brick, stone, and clay(?) title linning. I am looking into gas logs to replace dealing with wood. YES, a sealed unit would be FAR economical...
Replies: 2
Views: 96
Posted By bill1925

I had looked but I guess I did not look in the...

I had looked but I guess I did not look in the right place. THANK YOU.
Replies: 2
Views: 96
Posted By bill1925

Code for NYC + gas logs

Does anyone know where to get the code for installing gas logs in a wood-burning masonry fireplace, in NYC?
Replies: 1
Views: 210
Posted By bill1925

Hooking natural gas to gas logs.

I have a wood-burning fireplace. In the back is a vent that I can dump ashes. I also have a ventilator insert (1/2 in thick steel, no fans) in the fireplace. I can get a gas black pipe to the bottom...
Replies: 7
Views: 384
Posted By bill1925

Recessed light for room

My living room is 18.6ft (to rail) X14ft and 8 ft high.Enclosing pictures. I am thinking of 6 cans either 5 or 6 in. Wife will probably go with 5in. A number of places say take the sq footage and...
Replies: 8
Views: 377
Posted By bill1925

The wall paper is about 10 years old or so. I...

The wall paper is about 10 years old or so. I think I did use a primer before putting the wall paper on. Really do not want a problem with the new paint job So I will get some of the GAARDZ or oil...
Replies: 8
Views: 377
Posted By bill1925

Just took wallpaper off wall.

I just removed wall paper from the wall. I have rinsed the wall. Should I do any thing else before putting primer on the wall before I paint?
Replies: 2
Views: 259
Posted By bill1925

Disk brakes

I have a 2015 Honda CR. The top 1 in of the rear rotor has rust on it. It is starting to make noise. How can I remove it or clean it. Does that mean the pads are not applying pressure evenly to...
Replies: 1
Views: 293
Posted By bill1925

Radiant heat for the floor problems

I have radiant heat for the floor.There had been a leak and the problem was the Honeywell super vent-PV-075. It was always cracked open on top a little to let out air. Looks like water was coming out...
05-31-19, 07:30 AM
Replies: 1
Views: 639
Posted By bill1925

DeLong Hi Portable AC

Model# PACAN125 HPEC-3A------Serial # 41122 (9000053P03330)
With the unit running the AC display drops from 75 to 65 in two minutes and unit goes off on temp. The unit comes back on in about 5...
Replies: 5
Views: 489
Posted By bill1925

One problem was the supply side pump. It was...

One problem was the supply side pump. It was going on and off. Why have no idea. That was why the return temp was higher than the supply temp going into the heat exchanger.
The other was under...
Replies: 1
Views: 321
Posted By bill1925

How high to cut pcv from trap to base of shower

Installing hew shower base made of plastic(?). Have replaced old metal pipes to main where water goes down to next floor with PCV. How high is the piece of PCV from trap to connector at base of new...
Replies: 5
Views: 489
Posted By bill1925

I did not combine the threads. As stated I had...

I did not combine the threads. As stated I had two post.
Replies: 5
Views: 489
Posted By bill1925

The return temp is higher than the supplyof hot water boiler

I have a hot water boiler and have a pump to feed a heat exchange--HE. The HE feeds the radiant floor . I have found that the temp of the return is usually about 5-10 higher than the supply from the...
Replies: 5
Views: 489
Posted By bill1925

Not getting heat out of heat exchanger

I have supply from boiler at about 150 and the return at about 155-160 (yes the numbers are right,the return is higher,asking why in next post). The return from the radiant floor heat is about 80...
02-28-19, 05:26 PM
Replies: 5
Views: 552
Posted By bill1925

Have to move shower drain about 3 in

I have to move the shower drain about 3 in to the back wall. The old drain was 16 1/2 from back wall and the new drain is 13 1/2 from back wall. I have enclosed pictures. It is all case iron. Really...
Replies: 4
Views: 504
Posted By bill1925

How to remove drain in stall shower

I am replacing the shower base . I have enclosed picture of drain after we cut out the base. How do we remove the drain part so we can get to pipe in side the drain? The shower base is a little over...
Replies: 3
Views: 575
Posted By bill1925

I have included a picture from the box it came...

I have included a picture from the box it came in. Can you repair these TMV or is it best to be replaced. Is the AM101-us-1LF the same as the one I have AM101r-us-1,just a newer model.
Replies: 3
Views: 575
Posted By bill1925

Thermostatic mixing valve might not be working

I had thought maybe the pump was bad but It looks like the Thermostatic mixing valve might be bad. Leading up to the TMV the water is hot (pipe is hot) going into the TMV. I have two temp gauges one...
Replies: 5
Views: 367
Posted By bill1925

Removed the end cap and it was spinning. I...

Removed the end cap and it was spinning. I believe the problem is the thermostatic mixing valve and will start new topic.
Replies: 5
Views: 367
Posted By bill1925

Hear clicking sounds from motor

I have had this pump for abut 15-20 years. It pumps the hot water in the floor (radiant). I happen to go down stairs and the pump is making a clicking sound. I can see the needle jump in the pressure...
Replies: 2
Views: 2,101
Posted By bill1925

Info about NVR and OVER DECODE ABILITY

I have an 4K IP-16 chan NVR system (not a name brand). The IP cameras are wired with cat 6. Is it common to not be able to say play back 4 channels in 4k with out----OVER DECODE ABILITY?
Replies: 5
Views: 553
Posted By bill1925

OK I have forgotten a lot about the different...

OK I have forgotten a lot about the different connection. The mic that you showed me had a red and white connector. Do I get another connector to plug into the cameras audio in. If you can see the...
Replies: 5
Views: 553
Posted By bill1925

I have tried to re-post but having difficultly....

I have tried to re-post but having difficultly. the part hat I am interested in is
1-- AUDIO IN--AUDIO INPUT PORT--RCA--INPUT AUDIO SIGNAL RECEIVE ANALOG AUDIO SIGNAL FROM PICK UP AND ETC
...
Showing results 1 to 25 of 189
 


 
Forum Jump