Search: Posts Made By: 4135V
Showing results 1 to 25 of 49
Search took 0.01 seconds.
Replies: 11
Views: 511
Posted By 4135V

Had a nice online chat with Linksys support and...

Had a nice online chat with Linksys support and they walked me thru setting up the secondary router LAN to LAN. Even though they let me know I was 2 years out of factory support, they helped anyway....
Replies: 11
Views: 511
Posted By 4135V

Yes, the diagram helped a lot. If you are...

Yes, the diagram helped a lot.
If you are correct my neighbor would be computer H. So she could possibly be able to connect to any hardwired things I plugged into that router #2 and any Wifi ( Ipad,...
Replies: 11
Views: 511
Posted By 4135V

update

I found a Linksys EA7500 on FB marketplace for $20. I have set it up with Linksys smart wifi program and have changed the SSID and passwords to get in. Using a LAN to WAN setup I have the...
Replies: 11
Views: 511
Posted By 4135V

Thanks for the suggestions. I'll let you know...

Thanks for the suggestions. I'll let you know what I come up with, it might take a few days.
Replies: 11
Views: 511
Posted By 4135V

WiFi Security

I have a neighbor who is still using dial up internet on a Win95 computer. I want to let her use my wifi network by putting my router in a window facing her house ( I've stood outside her house with...
08-22-20, 11:49 AM
Replies: 10
Views: 218
Posted By 4135V

Garage Lighting

I currently have 48" flourescent tube 1-1/4" dia. fixtures. Since I need to replace several of the tubes, do you suggest I go to the newer LED bulbs? I see some of them require removing the ballast...
Replies: 1
Views: 1,668
Posted By 4135V

Try the https://www.avsforum.com/forum ...

Try the https://www.avsforum.com/forum maybefind the answer there
05-13-19, 07:19 AM
Replies: 1
Views: 433
Posted By 4135V

Heatpump Capacitor Question

Replaced the capacitor on my 8 yr old heatpump (it was still working) as a preventative measure because it seems caps and contactors are common problems.
BUT, the new (no name brand) one I bought...
05-12-19, 08:22 AM
Replies: 4
Views: 1,066
Posted By 4135V

installed a new capictor and unit is running....

installed a new capictor and unit is running. Thanks
05-11-19, 12:15 PM
Replies: 4
Views: 1,066
Posted By 4135V

Update: outside fans turns on again after a while...

Update: outside fans turns on again after a while and you can hear the compressor hum for about 5 seconds then stop.
05-11-19, 08:19 AM
Replies: 4
Views: 1,066
Posted By 4135V

Thermal Lockout

Bryant 265ANA048 Heatpump installed in 2008
Running in AC mode everything good until last night. Woke up to warm house this morning.
Took cover off the outside unit and was getting code 82...
Replies: 5
Views: 452
Posted By 4135V

Try to get the same color mortar that was used...

Try to get the same color mortar that was used previously. You may have to go to a brick supplier to get what you need, big box stores only carry a small sample of whats available.
Replies: 15
Views: 684
Posted By 4135V

Looking at the picture, there seems to be a wet...

Looking at the picture, there seems to be a wet spot on the floor under the pressure tank. Possibly the tank is failing?
01-15-19, 09:40 AM
Replies: 15
Views: 1,128
Posted By 4135V

Ballast Resistor

If the wiring is not original make sure there is a ballast resistor in the wire going to the points. Old cars had them on the firewall and if it was bypassed it would melt the points after a short...
01-10-19, 06:47 PM
Replies: 8
Views: 560
Posted By 4135V

In my area many companys are using "directional...

In my area many companys are using "directional drilling" to install new water,gas and even sewer lines. You only need to dig where it starts and ends. You may want to check on that option. Possibly...
12-17-18, 04:50 PM
Replies: 1
Views: 311
Posted By 4135V

Air compressor motor wont start

Older (30 yrs) compressor was being used and suddenly tripped the breaker when trying to start. Motor humms loudly and while humming you can't move the pulley. When you unplug the unit the pulley...
12-03-18, 06:14 PM
Replies: 7
Views: 586
Posted By 4135V

You may try using a tiny screwdriver to spread...

You may try using a tiny screwdriver to spread open the male pins on the board connector. Try that before ordering a new board.
10-20-18, 08:59 AM
Replies: 1
Views: 312
Posted By 4135V

Outside unit draws more amps in heat mode

10 yr old Bryant 265ANA048 condenser. When in cool mode unit draws 10.25 amps, when in heat mode 14 amps. Is this something I should be concerned about? Just got a clamp on meter so I've never...
Replies: 7
Views: 752
Posted By 4135V

If the compressor clutch kicks in and is turning,...

If the compressor clutch kicks in and is turning, one of the lines coming from the compressor should be very cold. If not, probably low on freon.
Replies: 1
Views: 495
Posted By 4135V

I would start by looking up CertainTeeds' website...

I would start by looking up CertainTeeds' website and finding out anything relating to the installation instructions for that product. Such as the amount of overlap at seams and edge terminations.
Replies: 8
Views: 649
Posted By 4135V

Look on youtube for "replacing shingles that blew...

Look on youtube for "replacing shingles that blew off". That will give you an idea of how its done, watch a few of them. There shouldn't be any nail heads visible when you are finished. Let us know...
Replies: 6
Views: 841
Posted By 4135V

Smooth wall PVC will flow much more water than...

Smooth wall PVC will flow much more water than the corrugated design, during heavy downpours. The corrugated is easier to install but why not do everything possible to correct your problems the 1st...
06-19-18, 10:04 AM
Replies: 37
Views: 1,662
Posted By 4135V

Since you had every breaker off EXCEPT stove...

Since you had every breaker off EXCEPT stove and Refrig when the FPL people checked, I would suspect one of those 2 circuits. Circuit board in the refridge keeping the defrost on or bad switch on...
05-18-18, 07:50 AM
Replies: 6
Views: 767
Posted By 4135V

Finally installed the pressure regulator valve,...

Finally installed the pressure regulator valve, works great! I did have to install a expansion tank as recommended. Biggest problem was the incoming line from the street was directly behind the water...
03-29-18, 03:01 PM
Replies: 6
Views: 767
Posted By 4135V

Sizing a Pressure reducing valve

My water pressure fluctuates between 75 and 95psi in about 15 seconds during the day. No water running in the house. You can hear the water heater popping as it expands and contracts. I'm tired of...
Showing results 1 to 25 of 49
 


 
Forum Jump