Search: Posts Made By: danoer1
Showing results 1 to 8 of 8
Search took 0.01 seconds.
06-24-10, 04:29 PM
Replies: 11
Views: 4,719
Posted By danoer1

thanks again for all your time with the posts. ...

thanks again for all your time with the posts.

so the breaker I have is a double pole 60 amp one, and the GFCI is a 50 amp. Am I ok with that?

The large 6" junction box is what I was...
06-24-10, 03:48 PM
Replies: 11
Views: 4,719
Posted By danoer1

thanks for that clarification. So I am good to...

thanks for that clarification. So I am good to use it for the interior run, but am stuck with too short of a length. The requirements for the spa are 240 V 32 amp rating with 3 wire + ground branch...
06-24-10, 03:15 PM
Replies: 11
Views: 4,719
Posted By danoer1

so this cable is not legal for a spa? ...

so this cable is not legal for a spa? http://img708.imageshack.us/img708/3865/photoon20100624at1712.th.jpg (http://img708.imageshack.us/i/photoon20100624at1712.jpg/)

dan
06-24-10, 02:09 PM
Replies: 11
Views: 4,719
Posted By danoer1

thanks for the response... I am using 6...

thanks for the response...

I am using 6 gauge stranded copper wire that is in a Romex sheath. 3 stranded wires plus a solid ground. It is a 240 V spa. Now the ground wire in the Romex cable I...
06-24-10, 12:26 PM
Replies: 11
Views: 4,719
Posted By danoer1

thanks for the reply. A few questions Here...

thanks for the reply. A few questions

Here is an image of the GFCI setup http://img145.imageshack.us/img145/3846/gfcilabelled.th.png (http://img145.imageshack.us/i/gfcilabelled.png/) I was given...
06-24-10, 08:13 AM
Replies: 11
Views: 4,719
Posted By danoer1

hot tub wiring questions

This is in regards to the following post: http://forum.doityourself.com/electrical-c-d-c/427352-hot-tub-help.html


I'm jumping in here since I happen to also be installing a used hot tub...
Replies: 3
Views: 1,176
Posted By danoer1

Thanks for the suggestions...The model # on the...

Thanks for the suggestions...The model # on the engine is Briggs & Stratton 121602. It is a 4 cycle 6.5 hp that is supposed to run in the 3000 to 3200 rpm range. Govenor spring eh? Well inbetween...
Replies: 3
Views: 1,176
Posted By danoer1

high rpm at idle

Have a John Deere push mower powered by a Briggs and Straton 6.5 hp engine with overhead valves. The mower is self propelled, but does not have a variable idle. My original problem was a no start...
Showing results 1 to 8 of 8


 
Forum Jump