Search: Posts Made By: HVAC122
Showing results 1 to 13 of 13
Search took 0.01 seconds.
10-17-08, 08:12 AM
Replies: 9
Views: 5,638
Posted By HVAC122

Looks like it could be a dirty flame sensor. It...

Looks like it could be a dirty flame sensor. It would most likely be on by the last burner on the right. It is just a rod that has one wire going to it. Clean this with some scotchbright or a...
09-23-08, 06:55 AM
Replies: 3
Views: 980
Posted By HVAC122

Your system is supposed to be sealed. We always...

Your system is supposed to be sealed. We always find the leak and give the owner the option of repair unless the owner dosn't want it found.

With the electronic leak detectors on the market today...
09-22-08, 07:06 PM
Replies: 11
Views: 2,070
Posted By HVAC122

Just have this friend get it for you. If he is a...

Just have this friend get it for you. If he is a licenced tech then it should not be a problem. Then you will have his labor warranty also and be covered by his insurance in case something happens.
09-22-08, 01:19 PM
Replies: 11
Views: 2,070
Posted By HVAC122

Don't buy on the internet.:)

Don't buy on the internet.:)
03-17-08, 07:44 AM
Replies: 23
Views: 6,419
Posted By HVAC122

Usually a limit tripping will leave the main...

Usually a limit tripping will leave the main blower running for saftey reasons.
02-04-08, 12:58 PM
Replies: 6
Views: 2,690
Posted By HVAC122

I don't know York models very well. Yours looks...

I don't know York models very well. Yours looks like a 80% furnace and the other looks like a 90% furnace. The 90% would have a sealed combustion chamber so it is not a apples to apples comparison....
02-04-08, 07:45 AM
Replies: 16
Views: 12,655
Posted By HVAC122

Make sure when he comes back that he checks the...

Make sure when he comes back that he checks the heat exchanger for cracks. The wisper heat has a Duracurve heat exchanger and they are usually cracked right at the curve. Don't through good money...
02-04-08, 07:34 AM
Replies: 10
Views: 2,415
Posted By HVAC122

Depends on the year of the furnace and the cost...

Depends on the year of the furnace and the cost difference. Personaly I would replace the furnace. It sounds like he did a good job of testing and explaining why it was bad. Many houses are short...
01-28-08, 07:32 AM
Replies: 4
Views: 1,127
Posted By HVAC122

Just a safety note. The wisper heat has a...

Just a safety note. The wisper heat has a duracurve heat exchanger and 90% of the time these are cracked. This would creat a very dangerous problem. I would have it checked by a pro. Its a small...
01-22-08, 08:01 AM
Replies: 7
Views: 1,837
Posted By HVAC122

Frigidaire would have had a 8 year parts...

Frigidaire would have had a 8 year parts warranty. How would they have known if it was installed wrong? Was it installed wrong? Venting is not determined by furnace size but by how long the vent...
Replies: 4
Views: 19,967
Posted By HVAC122

Would it be possible to move your supply under...

Would it be possible to move your supply under the window or on the outside wall? This would be your best bet as thats where the loss is. If there is a return there get rid of it and use you old...
Replies: 2
Views: 2,744
Posted By HVAC122

One other option is that you are burning candles....

One other option is that you are burning candles. This will also cause soot around registers. It is a common problem.
12-21-07, 07:26 PM
Replies: 2
Views: 850
Posted By HVAC122

It could be that the system needs to be balanced....

It could be that the system needs to be balanced. [I]f you open the by-pass more does the noise stop? It also could be one of the dampers leaking by or improper duct sizing and by-pass.
Showing results 1 to 13 of 13


 
Forum Jump