Search: Posts Made By: deerpark
Showing results 1 to 25 of 34
Search took 0.01 seconds.
Replies: 7
Views: 2,460
Posted By deerpark

I finally tackled this. I removed the fittings...

I finally tackled this. I removed the fittings that screw into the heating coil and there was no build up at all so I decided not to change it. I just replaced all the fittings and pipes that were...
01-16-19, 09:26 AM
Replies: 10
Views: 2,960
Posted By deerpark

Yeah, they were installed on the drywall. I just...

Yeah, they were installed on the drywall. I just removed them one by one and planning now to seal it and install a Kohler wall panel.
01-16-19, 04:19 AM
Replies: 10
Views: 2,960
Posted By deerpark

Thank you all, I've decided to move it to a...

Thank you all, I've decided to move it to a different wall after all. Here is a picture of the niche. Appreciate all the input.
01-15-19, 01:07 PM
Replies: 10
Views: 2,960
Posted By deerpark

Thank you Dane but the wall is parallel to the...

Thank you Dane but the wall is parallel to the joists, and perpendicular to the support beams. Does this change anything? Thanks again.
01-15-19, 12:56 PM
Replies: 10
Views: 2,960
Posted By deerpark

Cutting studs to install niche

Hi everyone, I am trying to install a niche in a wall in my master bathroom but there are two studs 5" O.C. right in the middle of it. The wall is perpendicular to the support beams. The opening is...
Replies: 14
Views: 1,305
Posted By deerpark

Good point, I'll keep this in mind. Appreciate...

Good point, I'll keep this in mind. Appreciate your response.
Replies: 14
Views: 1,305
Posted By deerpark

ok, thank you for pointing that out. I'll take a...

ok, thank you for pointing that out. I'll take a good look once I put it apart.
Replies: 14
Views: 1,305
Posted By deerpark

Yes, thank you, I am planning to change all bad...

Yes, thank you, I am planning to change all bad plywood. I am not sure about which rafter you are referring to. What is the picture number?
Flat roof is joined with the upper roof by going...
Replies: 14
Views: 1,305
Posted By deerpark

Thank you for the recommendation. I got another...

Thank you for the recommendation. I got another estimate....even higher than the previous one. They were going to use EPDM membrane.
I went ahead and caulked all around the edges and so far no...
Replies: 14
Views: 1,305
Posted By deerpark

Here are more pictures I just took this morning. ...

Here are more pictures I just took this morning. Maybe I am over reacting and all it needs is new caulking all around both roofs. Ideally I should re do the edges so the rubber wraps around and...
Replies: 14
Views: 1,305
Posted By deerpark

I still haven't replaced this flat roof. I just...

I still haven't replaced this flat roof. I just had another leak so I really need to get this done. The company that gave me the $3k estimate is too busy right now so I got another...
Replies: 7
Views: 2,460
Posted By deerpark

Thank you, I'll keep this in mind and will make...

Thank you, I'll keep this in mind and will make sure i have the proper tools before I start. I'll start squirting some Kroil penetrating oil and hopefully it will help.
Replies: 7
Views: 2,460
Posted By deerpark

Great! That's exactly what I was looking for. I...

Great! That's exactly what I was looking for. I should be able to just cut the pipes, and then install new ones with the new heater. Thank you for all your help.
Replies: 7
Views: 2,460
Posted By deerpark

Thank you PJmax for the quick response. I had...

Thank you PJmax for the quick response.
I had tried to fix the leak with high temp epoxy putty but still leaks a little bit right by where it meets the nut that screws into the black round panel. ...
Replies: 7
Views: 2,460
Posted By deerpark

Need to change parts on Burnham V-74-T boiler

Hi, my Burnham V-74-T boiler needs the swing door mounting plate, front cover, and front panel replaced. Please see attached pictures. A small leaked damaged the parts.
Is this a DIY job? Where...
Replies: 14
Views: 1,305
Posted By deerpark

FYI, I just got an estimate to do this roof plus...

FYI, I just got an estimate to do this roof plus another flat roof aprox 30' x 25' for $3000. This other roof is much higher up so I am not thinking of doing it myself.
Is this a good price? I am...
Replies: 14
Views: 1,305
Posted By deerpark

Thank you guys. I attached some pictures. The...

Thank you guys. I attached some pictures. The slope is about 12".
Replies: 14
Views: 1,305
Posted By deerpark

Low slope roof - DIY?

Hi everyone, I have a low slope roof over my sunroom. I can tell the plywood at the edge by the gutters is expanding and creates an area along the edge where the water sits. I've been at this house...
05-26-15, 05:09 AM
Replies: 6
Views: 982
Posted By deerpark

Thank you to both of you. I watched the video...

Thank you to both of you. I watched the video and ordered all the parts from windowparts dot com. I am kind of surprised the springs are $30 each but it is what it is. Appreciate all your help!
05-22-15, 12:20 PM
Replies: 6
Views: 982
Posted By deerpark

Thank you XSleeper. The spring loaded cord pack...

Thank you XSleeper. The spring loaded cord pack says "Andersen". The glass says Andersen AW 2-4.
Yes, the jambs are vinyl and I already removed the screws you are mentioning. I just tried again...
05-22-15, 11:19 AM
Replies: 6
Views: 982
Posted By deerpark

Can't figure out how to remove old windows for servicing - 1966 home

Hi everyone, I've been trying to figure out how to remove my windows. I need to paint them, and replace the sash cords on many of them. The house was built in 1966 and these are the original...
08-22-13, 11:06 AM
Replies: 7
Views: 14,505
Posted By deerpark

Finally got the estimate. $2800 to do the whole...

Finally got the estimate. $2800 to do the whole kitchen ceiling. Way more than want to spend on this.
I asked him how about just to repair the hole and he said $200. I thought it was fair so I...
Replies: 11
Views: 4,192
Posted By deerpark

Good to know. I'll run it by him. I checked the...

Good to know. I'll run it by him. I checked the coupler and he did install the clamp pass the hub of the elbow. Thank you again.
Replies: 11
Views: 4,192
Posted By deerpark

UPDATE: Leak fixed. Flange, elbow, and pipe had...

UPDATE: Leak fixed. Flange, elbow, and pipe had to be replaced. Took him 3 hours and charged me $350. Super nice and knowledgeable person. Will definitely use him again.
Now moving on to the...
07-29-13, 10:15 AM
Replies: 7
Views: 14,505
Posted By deerpark

Good point Mark. Someone is coming this...

Good point Mark. Someone is coming this afternoon to give me an estimate. Thank you.
Showing results 1 to 25 of 34
 


 
Forum Jump