Search: Posts Made By: endeavour
Showing results 1 to 25 of 89
Search took 0.02 seconds.
06-09-20, 08:30 AM
Replies: 3
Views: 275
Posted By endeavour

That's the picture of my fence, sorry if i wasn't...

That's the picture of my fence, sorry if i wasn't clear. I was comparing this pic to the HD link. HD Post has slightly different top pattern but has three holes similar to what I have.

The fence...
06-08-20, 06:48 PM
Replies: 3
Views: 275
Posted By endeavour

Need help replacing vinyl fence end post

I need to replace the end post of my vinyl fence due to damage. I am confused what size fence post should i buy. The exposed part of the fence is 6 ft tall from the ground, how much is inside the...
Replies: 1
Views: 265
Posted By endeavour

How to tap existing HVAC duct

I have a bunch of fish tanks in my basement and need to keep them at normal temperature (72 - 78) in hot NYC summer. I have central AC HVAC ducts running through my basement. How can I tap into my...
Replies: 19
Views: 718
Posted By endeavour

Thanks Norm. The circumference of the iron pipe...

Thanks Norm. The circumference of the iron pipe (pipe coming out from the wall) is 7 1/2 which translates to 2".

CasualJoe - Correct, the house is over 100yrs old! I don't think i can handle the...
Replies: 19
Views: 718
Posted By endeavour

Here is a pic from the side. The drain pipe...

Here is a pic from the side. The drain pipe inside the wall is def bigger than the brass elbows and i checked outside circumference, it translates to 2". I have the necessary tools mentioned below...
Replies: 19
Views: 718
Posted By endeavour

Thanks PJ. Why would the 1-1/2 rubber slip joint...

Thanks PJ. Why would the 1-1/2 rubber slip joint not work? is it because the wall drain pipe is 2" and i would need a reducer nipple ie 2" female to 1-1/2 male?
Replies: 19
Views: 718
Posted By endeavour

Exactly, I end up going to the store multiple...

Exactly, I end up going to the store multiple times almost always for jobs like this.
Unfortunately i cannot ride this out for more than a couple of days but the duct tape seem to be working and had...
Replies: 19
Views: 718
Posted By endeavour

Manden is correct, there is a trap a the bottom...

Manden is correct, there is a trap a the bottom towards the wall. Here is a better pic. The set up has been like this from previous owner and we moved into this house 10 yrs ago. No issues so far. I...
Replies: 19
Views: 718
Posted By endeavour

Kitchen sink leaking, need help with identifying parts

So my kitchen sink started leaking today. It's leaking where the small circle is marked. I believe its time to replace the right angle fitting. I am not sure what is that fitting called and what type...
Replies: 4
Views: 366
Posted By endeavour

Thanks Xsleeper. I will look into mudjacking. In...

Thanks Xsleeper. I will look into mudjacking. In the meantime I was thinking to get Quick Dam sold on Amazon, its water activated and reusable (link below). Let me know if there is a better temporary...
Replies: 4
Views: 366
Posted By endeavour

Rain water flowing towards the house

Every time it rains, a little water accumulates by the back wall of the basement (the water has started seeping in). Please see the pic, the area where water is flowing to and stands is highlighted...
Replies: 5
Views: 547
Posted By endeavour

That is correct. Passenger front side spring is...

That is correct. Passenger front side spring is broken and bushing shot. My mechanic was saying its recommend getting the full set replaced instead of just springs and bushing and also do both front...
Replies: 5
Views: 547
Posted By endeavour

Replacing suspension system; Need advice.

My 2003 Toyota Sequoia has 127k miles and is in fairly decent shape. I feel there is still plenty of life left in it. The front bushing and springs are shot and needs replacement. Would you recommend...
Replies: 0
Views: 290
Posted By endeavour

Evaporative Emission Control System Leak

Getting code P0442 (slow leak in Evap system) in my 2003 Toyota sequoia. I did some research and started with replacing the gas cap, deleted the code and drove around for a few weeks but the light...
10-20-19, 08:38 PM
Replies: 1
Views: 245
Posted By endeavour

Window AC not blowing cool air, condenser seem to be fine

AC turns on fine, fan runs for about a minute and then condenser kicks in but it's not blowing cool air (I tested this during hot summer days). No unusual noise. I opened up the casing and as...
Replies: 8
Views: 424
Posted By endeavour

Thanks. Since the circulator keeps running even...

Thanks. Since the circulator keeps running even though the boiler has shut off (after reaching 200F), I have been turning the circulator off by reducing the temperature on the Tstat (I raise the temp...
Replies: 8
Views: 424
Posted By endeavour

Thanks for the replies. Tomf63, I have...

Thanks for the replies.

Tomf63, I have radiators. Boiler is currently set at 200 so I am maxed out. Yes the boiler is reaching 200 and shuts (while the pump keep running, is the pump suppose to...
Replies: 8
Views: 424
Posted By endeavour

Considering getting auxiliary heat but don't know where to start

I currently have a single zone water heating system (natural gas) that is about 6 years old. I am pretty happy with it and it handles most of the colder days like a champ. The only problem is on...
Replies: 7
Views: 516
Posted By endeavour

Clicking noise from front wheels

My 2011 Toyota camry sometimes makes 2 to 3 clicking noise when making turns (unable to pinpoint if its right or left turn, sometimes its random). I googled this and found the issue possibly could be...
Replies: 12
Views: 1,748
Posted By endeavour

You are correct, there is an inside panel which...

You are correct, there is an inside panel which will need to be removed to access the dent from inside. I got an estimate of $1200 to fix and i agree new hood will be less than that (online search is...
Replies: 12
Views: 1,748
Posted By endeavour

Dent on the hood

There is a decent size dent on my car hood. As this is on the hood should I try pushing the dent out from the inside or use something (like plunger or suction cup) to pull it out from outside? The...
Replies: 4
Views: 1,193
Posted By endeavour

Need help identifying part on 2006 BMW 325i E90

Just noticed this grommet is missing in my E90. Does anyone know the part number or the exact name? I tried looking up but I couldn't narrow down the part number. Thanks in advance!
04-03-18, 12:46 PM
Replies: 5
Views: 707
Posted By endeavour

Thank you. Any suggestions on how to prevent...

Thank you. Any suggestions on how to prevent insects from getting into the attic? I was thinking to put an insect screen (from the inside of the attic and not through the roof). Does anyone see any...
04-01-18, 07:37 PM
Replies: 5
Views: 707
Posted By endeavour

You are both correct. Its wind turbine and this...

You are both correct. Its wind turbine and this is how it looks from the outside. Am i supposed to shut the turbine in the winter months to prevent the hot air from escaping?

Also, the slots of...
04-01-18, 11:24 AM
Replies: 5
Views: 707
Posted By endeavour

What is this in the Attic?

My house has 2 attics, larger one on the side of the house and a very tiny one towards the top center of the house. Actually, I never realized there was a second attic until now. It has a tiny cutout...
Showing results 1 to 25 of 89
 


 
Forum Jump