Search: Posts Made By: Kokomo
Showing results 1 to 6 of 6
Search took 0.01 seconds.
12-14-07, 05:27 PM
Replies: 8
Views: 15,745
Posted By Kokomo

Thumbs up Furnace Fixed!

I bought a replacement ignitor the other day. I got it home and installed it only to find it performing worse than the old one. It measured 120 ohms resistance. I reinstalled the old one, moved the...
12-12-07, 01:49 PM
Replies: 8
Views: 15,745
Posted By Kokomo

I just went and tested it again. It's steady at...

I just went and tested it again. It's steady at 107. I couldn't find the exact specs for my brand but, I found specs for a universal replacement for my brand.
...
12-12-07, 01:32 PM
Replies: 8
Views: 15,745
Posted By Kokomo

Ok, I have a digital multimeter. I tested it...

Ok,

I have a digital multimeter. I tested it several times to be sure. It was still a little warm when I started testing and read around 92. As it cooled it started climbing and went to 102. I...
12-12-07, 01:05 PM
Replies: 8
Views: 15,745
Posted By Kokomo

I found this info searching around: ...

I found this info searching around:

Disconnect or remove igniter and measure its resistance. Cold resistance should be between 50 and 150 Ohms. (The value of the resistance is not important as...
12-12-07, 10:32 AM
Replies: 8
Views: 15,745
Posted By Kokomo

Thanks for that info. I did the ohms test and it...

Thanks for that info. I did the ohms test and it toped out at 102. What do you think?
12-11-07, 03:23 PM
Replies: 8
Views: 15,745
Posted By Kokomo

Hot surface igniter

Hello,

I have an American Standard/Trane furnace with a WhiteRodgers 50A65-843 control and a Norton 271N hot surface igniter. The control is brand new and the igniter is not so new. Just before...
Showing results 1 to 6 of 6


 
Forum Jump