Search: Posts Made By: 63zerb
Showing results 1 to 25 of 39
Search took 0.01 seconds.
Replies: 2
Views: 2,861
Posted By 63zerb

static on fm radio

I work in a wood shop. We are permitted to listen to radios. The building is metal or pole barn construction. my radio hardly ever comes in so I can clearly hear it. I have tried running copper wire...
Replies: 4
Views: 1,511
Posted By 63zerb

Formica top lifting

Hello,

My kitchen formica top is lifting at different areas. I used contact cement and clamped it down, it lifted again. The area it lifted is at the edge about 4-5 inches. What caused this and...
06-04-11, 05:43 AM
Replies: 9
Views: 1,198
Posted By 63zerb

pics

http://s912.photobucket.com/albums/ac325/63zerb/
can anyone open these?

http://i912.photobucket.com/albums/ac325/63zerb/Camper010.jpg
...
06-04-11, 05:30 AM
Replies: 9
Views: 1,198
Posted By 63zerb

Plug would be installed on a post concreted in...

Plug would be installed on a post concreted in with embedded 3/4 conduit to two gang outdoor box.
06-02-11, 05:24 PM
Replies: 9
Views: 1,198
Posted By 63zerb

Outdoor Temporary Service To Camper

My In Laws are coming from AZ to stay with us in PA. They will be in a camper in our yard for two months. The total run from panel box to camper is about 115 feet. I am not sure but I think the plug...
Replies: 6
Views: 8,176
Posted By 63zerb

fuel filter 1996 subaru legacy 2.2

I want to change fuel filters on my 1996 subaru legacy 2.2 the vehicle starts fine runs and then shuts off. I used an octane booster..still stalls out. My question... is there a release valve of...
Replies: 10
Views: 3,476
Posted By 63zerb

starter course....asphalt shingles

Hello I need some advice on how to start the starter course for asphalt shingles.I am pretty handy however shingles not one of my strong points.These are three tab asphalt shingles going on my 12x 16...
07-24-10, 08:13 AM
Replies: 8
Views: 1,448
Posted By 63zerb

neutral tab ....

Thanks for the input....i am going to break off neutral tab and this will solve issue of gfi tripping.
07-24-10, 08:07 AM
Replies: 9
Views: 3,759
Posted By 63zerb

disposal only...

It is a weird set up yes......there is no dishwasher in kitchen.
07-21-10, 06:13 PM
Replies: 8
Views: 1,448
Posted By 63zerb

see thread on 7/14/2010

ray look at my thread I posted on 7/14/2010 about gfi keeps tripping.

http://forum.doityourself.com/electrical-c-d-c/429034-gfi-keeps-tripping.html
07-21-10, 06:06 PM
Replies: 8
Views: 1,448
Posted By 63zerb

Breaking tab off netural side in recep.

Is it a safe and good practice to break off netural tab in recep. I have to separate circuits in one recep. My newly installed gfi keeps tripping. I am speculating the gfi sences a leak in netural.
07-14-10, 04:35 PM
Replies: 9
Views: 3,759
Posted By 63zerb

apbrooks,frenchy, second opinion....

Thanks mikerios I have never heard, nor did this and not sure if safe practice. Can other moderaters help me out here for your input apbrooks,frenchy,chancler what do ya' say
07-11-10, 07:03 PM
Replies: 9
Views: 3,759
Posted By 63zerb

recep B has two 12-2.......

Mikerios....thank you for your help.....what an awsome drawing this is close to my set up.The 12-3 red is on the left of switch.This is probably the switch leg for light.There are no red legs in...
Replies: 2
Views: 846
Posted By 63zerb

frozen tube..

Thanks Chandler I will try this in the morning. It is 10 PM in PA. and I am turning into a hoot owl...good night!
07-10-10, 07:51 PM
Replies: 9
Views: 3,759
Posted By 63zerb

possible shared netural....

In recep B bottom of recep is switch leg for garbage disposal. Recep B top is always hot coming off of recep A. The switch at counter on own circuit is the type where they are stacked on top of each...
Replies: 2
Views: 846
Posted By 63zerb

Maytag Refrig. Defrost issue

We have a Maytag Side-by-Side (Frost-free) Refrig./Freezer that is accumulating moisture on the bottom of the freezer side. As this moisture builds up, it forms to a frozen puddle of water on freezer...
07-10-10, 04:43 PM
Replies: 9
Views: 3,759
Posted By 63zerb

GFI Keeps Tripping

I installed a GFI at sink counter top to bring to code. The wire is romex 20 amp #12 on 20 amp breaker.The existing wire in box are all two wire.Hot, netural, and ground.There are three sets of two...
03-13-10, 05:48 AM
Replies: 2
Views: 851
Posted By 63zerb

Bathroom Fan, Heater and Light

I have a bathroom heater with fan and light. The old unit I removed had same ...Heater light and fan. The old existing wires are romex 20 amp # 12. There are two sets of old wires existing with 2...
11-26-09, 06:35 PM
Replies: 4
Views: 954
Posted By 63zerb

That is why this trade interest me so much.

That is why this trade interest me so much.
11-26-09, 06:09 PM
Replies: 8
Views: 1,018
Posted By 63zerb

Are you able to close these in winter to heat...

Are you able to close these in winter to heat building?Can you show an pic of some
11-26-09, 09:20 AM
Replies: 4
Views: 954
Posted By 63zerb

Switch Loop

For my own educational purposes I am trying to figure out why the last homeowners electrician went through the xtra work and wire for this switch loop.
I tore all the extra wire out about 30-40...
11-24-09, 03:43 PM
Replies: 8
Views: 1,018
Posted By 63zerb

] The door was cut crooked toward top right. ...

]
The door was cut crooked toward top right.


The door is actually plumb.....maybe a "hair" off but nothing like a bubble out of plumb.


I will try this.Perhaps straight lining the door on...
11-24-09, 09:25 AM
Replies: 8
Views: 1,018
Posted By 63zerb

A Window and Door Question....

My Window Question:I want to install windows in my shed.There are curently none.The siding is T-111.All of the old T-111 will be removed due to rot etc...I looked at Windows at the blue store and saw...
11-21-09, 05:07 PM
Replies: 6
Views: 22,039
Posted By 63zerb

Plastic Crown....

Thank You Bud and Dane for the input/ links on vapor barriers and crawl spaces,they were very educational.



Bud,what do yo mean about a crown in plastic?

I had a shed on our other...
11-20-09, 08:25 AM
Replies: 6
Views: 22,039
Posted By 63zerb

Vapor Barrier

[QUOTE]I would put a vapor barrier (sheet plastic) underneath before installing the floor and I would install some vents in the shed for ventillation. [QUOTE]

Thanks Dane for input.....A buddy of...
Showing results 1 to 25 of 39
 


 
Forum Jump