Search: Posts Made By: bperry
Showing results 1 to 25 of 94
Search took 0.02 seconds.
01-23-18, 05:32 PM
Replies: 5
Views: 1,224
Posted By bperry

I had one installed and he installed it in the...

I had one installed and he installed it in the crawl space and ran a line to the sink , where he installed a faucet and a line to refrigerator. No longer need a filter and great water for ice and...
Replies: 16
Views: 1,002
Posted By bperry

I have 2 scanners. One is actron and one is...

I have 2 scanners. One is actron and one is harbor freight which I bought at a yard sale. I like it best ,it identifies problem and erases codes. So does the actron but it cost me about $80. and the...
Replies: 5
Views: 976
Posted By bperry

I had a Visio and after 14 months it did the same...

I had a Visio and after 14 months it did the same thing estimate to repair was more than a new TV, bought a 50" samsung smart tv. Recently wanted a tv for dining room so I bought a 32" Visio set it...
02-20-16, 05:26 PM
Replies: 53
Views: 2,400
Posted By bperry

I had good luck removing wallpaper by scoring it...

I had good luck removing wallpaper by scoring it and just spray it with hot water from a garden sprayer. let it set a few min and what did not come off we sprayed again. finally got it all off...
Replies: 9
Views: 873
Posted By bperry

Sorry it is pergo and the company says its the...

Sorry it is pergo and the company says its the only laminate recommended for baths and kitchens
Pergo Presto Lago Slate 8 mm Thick x 7-5/8 in. Wide x 47-5/8 in. Length Laminate Flooring (20.17 sq....
Replies: 9
Views: 873
Posted By bperry

Dupont makes a Laminate that looks like tile and...

Dupont makes a Laminate that looks like tile and is made specifically for kitchen and baths. I have it in my kitchen, it is over 5 years old and still looks new.
07-06-15, 12:31 PM
Replies: 8
Views: 771
Posted By bperry

My experience ,if you tape over the open pipe...

My experience ,if you tape over the open pipe then use shop vac at outlet end you will not only clean trap but opening in unit where condensate enters the pipe.
06-21-15, 01:07 PM
Replies: 10
Views: 14,637
Posted By bperry

That is a glacier bay part and replacement o...

That is a glacier bay part and replacement o rings or new cartridge should be available at the Home Depot. May be used by other mfgs also
Replies: 3
Views: 693
Posted By bperry

The Mower is model 917.203830 it has T2400 on...

The Mower is model 917.203830 it has T2400 on side of hood, 46" cut. 19 HP
Replies: 3
Views: 693
Posted By bperry

I will go over tomorrow and get model. Looked...

I will go over tomorrow and get model. Looked under and saw nothing wrong. I will look for a place a spring hooks. Thanks
Replies: 3
Views: 693
Posted By bperry

Craftsman riding mower

A freind has a 1.5 year old 42" Craftsman riding mower.It has a small lever in the rear that engages and disengages so you can push the mower. The lever does nothing and it is loose.(can move in and...
Replies: 3
Views: 478
Posted By bperry

Same thing happened to me. I purchased a metal...

Same thing happened to me. I purchased a metal ring that fit over the PVC and screw it down and new screws go in the metal ring.
04-09-15, 11:15 AM
Replies: 6
Views: 927
Posted By bperry

If you look outside you should see some plastic...

If you look outside you should see some plastic strips (seals) They can be pried off with a small putty knife. take off the seals, measure the width and height of glass and press the seals back in...
Replies: 4
Views: 754
Posted By bperry

Looks like an exterior wall to the left. You...

Looks like an exterior wall to the left. You could go up to top of cabinets, elbow to left and go thru upper cabinets thru wall. there are wall connections with self closing dampers. Don't know what...
Replies: 13
Views: 887
Posted By bperry

Go to this link and you can download a file to...

Go to this link and you can download a file to open a cal. file CAL File Extension - Open .CAL Files (http://fileinfo.com/extension/cal)
Replies: 13
Views: 1,051
Posted By bperry

heatworm thanks for the info good reading, lots...

heatworm thanks for the info good reading, lots of info.
Replies: 13
Views: 1,051
Posted By bperry

well I talked to rep. Going with the Multi/pak 80...

well I talked to rep. Going with the Multi/pak 80 and the default on boiler is 175 Deg but is adjustable down to 150 or up to 185.On a slab in crawl is OK for my area just have to install a...
Replies: 13
Views: 1,051
Posted By bperry

Thanks for all the input. I have done a room by...

Thanks for all the input. I have done a room by room heat loss and I was under the impression the boiler delivered 160 Deg water. I am talking to the distributor today and will get more info. As for...
02-17-15, 01:36 PM
Replies: 5
Views: 639
Posted By bperry

In our area a GFCI disconnect is required at or...

In our area a GFCI disconnect is required at or near the hot tub. You can purchase those at the orange box store and they are 50 amp.
Replies: 13
Views: 1,051
Posted By bperry

Yes I plan to put a high efficiency condensing...

Yes I plan to put a high efficiency condensing boiler with PVC exhaust and circulating pumps in a 5' tall crawl. Boiler will be on a concrete pad. Actually guys I am 75 but still very active and only...
Replies: 13
Views: 1,051
Posted By bperry

diy hydronic heat install

OK tell me if I am taking on too much or is this a DIY project. I presently have a gas pack with propane furnace and AC unit. all mounted outside. I want to install hot water base board heat. I can...
01-28-15, 06:52 AM
Replies: 13
Views: 989
Posted By bperry

I agree with that. I know a couple like that. I...

I agree with that. I know a couple like that. I have never been to court and they have. I take my work seriously and If I cannot do it with integrity I will retire. Thanks for the reply.
01-27-15, 07:58 PM
Replies: 13
Views: 989
Posted By bperry

I would not paint all home inspectors the same. I...

I would not paint all home inspectors the same. I am one and have been for 12 years. I know Cutler hammer and square d make breakers that 2 circuits can be serviced. First it must have a place for 2...
01-04-15, 07:05 AM
Replies: 6
Views: 705
Posted By bperry

Thanks confirms my thoughts.

Thanks confirms my thoughts.
01-03-15, 05:22 PM
Replies: 6
Views: 705
Posted By bperry

Yes they are vinyl and I have replaced 4 of the...

Yes they are vinyl and I have replaced 4 of the glass units already. local glass shop made them to fit and take out the vinyl lock outside and push out the old and silicon and push in the new and...
Showing results 1 to 25 of 94
 


 
Forum Jump