Search: Posts Made By: KennethW
Showing results 1 to 14 of 14
Search took 0.01 seconds.
Replies: 2
Views: 711
Posted By KennethW

Cable Railing Questions

I have built a new deck and I am planning to install stainless steel cable railing for the railings. I have 6 x 6 cedar corner posts that are notched around the rim joists and secured with two 8"...
07-05-15, 08:44 PM
Replies: 7
Views: 16,552
Posted By KennethW

The yard is fairly big, two acres. I guess the...

The yard is fairly big, two acres. I guess the weeds are worse in some areas so we could spot spray where the weeds are but was hoping I could put the weed and feed down to kill two birds with one...
07-05-15, 01:02 PM
Replies: 7
Views: 16,552
Posted By KennethW

Is Weed and Feed Application Ok in July

In the spring, I put down some new grass seed and I put down crabgrass preventer in other areas. However our lawn has many weeds. They are growing like crazy. I just picked up some weed and feed...
Replies: 1
Views: 926
Posted By KennethW

Whirlpool thermostat cold control replacement tube barrier

I am in process of replacing a Thermostat Cold Control 2161284 on a Whirlpool Refridgerator. However, I am unable to get the old Thermostat sensor barrier tube 1115241 that was on the old thermostat...
01-04-15, 10:45 AM
Replies: 2
Views: 1,119
Posted By KennethW

Thanks Biermech for the reply! I was able to...

Thanks Biermech for the reply! I was able to download the 9100 manual. I will read through and see if I can understand how to manually kick off the regeneration. I was thinking about scrubbing the...
01-03-15, 08:53 PM
Replies: 2
Views: 1,119
Posted By KennethW

Dual Tank Water Softener Advice

Hello H2O experts,

We just bought an 18 year old home outside Omaha, NE with a well, water softener and reverse osmosis system. I am completely new to non-city water and was hoping someone might...
11-10-06, 03:27 PM
Replies: 2
Views: 2,914
Posted By KennethW

Wood finishing questions: sanding, conditioner, etc.

Hello All!

I am in process of finishing our basement and we are using new oak moulding and new oak doors. I have a read quite a bit on the best practices of staining wood and had a few questions. ...
Replies: 1
Views: 1,025
Posted By KennethW

Sealing / Repairing Basement Floor Cracks

Hello – I have a 2 year old Nebraska home with a sump pump and drain tile around the foundation. I am finishing my basement and want to repair / seal several cracks in my basement floor. The cracks...
06-15-06, 10:29 AM
Replies: 5
Views: 2,060
Posted By KennethW

Basswood plantation shutters stained to match oak cabinet?

I am building an entertainment center for a TV and audio / video components. The cabinet will be finished in oak and stained. I want to use plantation shutters as cabinet doors for the audio / video...
Replies: 1
Views: 962
Posted By KennethW

Is it ok to T into another takeoff?

I am in the middle of finishing my basement of my new (2004) 2-story home. My supply trunk for the main floor runs down the middle of the basement and I have been running new takeoffs from the trunk...
Replies: 4
Views: 7,354
Posted By KennethW

Thanks for the reply Rob. I am using square...

Thanks for the reply Rob. I am using square takeoffs.
Replies: 4
Views: 7,354
Posted By KennethW

Best method to cut ductwork for top takeoff?

Hello - I am in the middle of finishing our basement of our new house and wanted to know the best method of cutting takeoffs into the main trunkline of the supply duct which runs across the joists in...
05-19-06, 05:41 PM
Replies: 4
Views: 13,411
Posted By KennethW

Thank you for your replies.

Thank you for your replies, I will do as you suggest and post the results. Thanks again.
05-16-06, 01:06 PM
Replies: 4
Views: 13,411
Posted By KennethW

Toning down too orange stain finish (Oak)

I have some leftover oak trim from my old house that I would like to use in my new house's basement. The problem is that I have already stained and added a polyurethane topcoat finish to the trim and...
Showing results 1 to 14 of 14


 
Forum Jump