Search: Posts Made By: JoeT
Showing results 1 to 8 of 8
Search took 0.01 seconds.
07-05-06, 03:57 PM
Replies: 1
Views: 2,702
Posted By JoeT

Adjust CPH for honeywell T8112

I have a forced air gas furance with a Honeywell T8112. How do I adjust the CPH on this thermostat so I can lower the CPH? The furance is 90% efficient. The thermostat maintains heat at one degree...
07-04-06, 04:07 AM
Replies: 5
Views: 1,187
Posted By JoeT

Whine in compressor after shut off

The big copper line does not feel warm or hot after the compressor shuts off. Checkvalve in compressor allowing leakage, will this cause problems down the road?
Joe
07-03-06, 08:57 AM
Replies: 5
Views: 1,187
Posted By JoeT

Whine at compressor after unit shuts off

Will this cause any damage or more wear and tear on the unit? Loss of gas?
07-03-06, 07:05 AM
Replies: 5
Views: 1,187
Posted By JoeT

Whine at compressor after unit shuts off

I have a new Armstrong furnace and central A/C put in last fall. When the compressor shuts off, outside, the fan in the furance runs for about 30 seconds, when it shuts off and maybe upto another 20...
Replies: 3
Views: 4,126
Posted By JoeT

Pump, louder noise

Ron

Its like when I had the pump inside the house, it was loud and then we got a new well, 4inch and pump in well, just low level hum and you had to listen for it, well now back to pump inside...
Replies: 3
Views: 4,126
Posted By JoeT

Pump noise, vibration type

Well is about 55 feet down, pump is in the well. When the pump use to turn on you could barely hear it vibrate. Last night the wife turned on the water sprinkling system for the grass. It ran ok for...
04-07-06, 04:52 AM
Replies: 10
Views: 2,333
Posted By JoeT

Its a Honeywell Electronic Programmable...

Its a Honeywell Electronic Programmable Thermostat, 4 settings for Mon thru Fri and two settings for Sat and Sun. Does both heating and cooling. Cannot find a model number on manual or Thermostat....
04-06-06, 03:29 PM
Replies: 10
Views: 2,333
Posted By JoeT

New Thermostat verus old thermostat

My old thermostat when set to 68, for heating, would come on at 67 and turn off around 69 - 79. My new thermostat with a new furnace, 93%, comes on at 68, set at 68, and goes off at 68. Is this...
Showing results 1 to 8 of 8


 
Forum Jump