Search: Posts Made By: bigbucky
Showing results 1 to 12 of 12
Search took 0.01 seconds.
Replies: 6
Views: 1,616
Posted By bigbucky

yeah, overall seemed like weird wiring. Thanks...

yeah, overall seemed like weird wiring. Thanks for your help!
Replies: 6
Views: 1,616
Posted By bigbucky

Thanks Pete, that makes sense. Any idea what...

Thanks Pete, that makes sense. Any idea what that white wire is?
Replies: 6
Views: 1,616
Posted By bigbucky

One of the red wires in the bottom picture is the...

One of the red wires in the bottom picture is the power source. It goes to the outlet in the first picture. So I guess the bottom picture is just a single pole switch. But why are the black and...
Replies: 6
Views: 1,616
Posted By bigbucky

Thought I was replacing a 3-way switch but only two wires on the switches

I have two occupancy switches for the hall lights. They both turn off and on the lights. But when I took out the switches they only have two wires. Pictures below.

The red wires are hot in both...
Replies: 6
Views: 1,917
Posted By bigbucky

thanks PJ! It's right next to the breaker box. ...

thanks PJ! It's right next to the breaker box. Can I just use the copper grounding wire from some 14/2 Romex? Is that ATT's responsibility?
Replies: 6
Views: 1,917
Posted By bigbucky

Here is a better picture of the terminal block...

Here is a better picture of the terminal block connections

42716
Replies: 6
Views: 1,917
Posted By bigbucky

Question about NID wiring: Is this the ground?

I am finishing my garage so I have to remove the NID to put up drywall. I'm trying to understand how it is wired. It looks like there is an old line from the telephone pole that comes in and...
Replies: 3
Views: 3,619
Posted By bigbucky

It's against an interior wall now and the duct...

It's against an interior wall now and the duct runs along that to the exterior wall where it vents now. I thought I could send it up inside the interior wall to the attic so it's not exposed.


...
11-06-14, 11:42 PM
Replies: 4
Views: 3,417
Posted By bigbucky

I would have thought cutting through the sill...

I would have thought cutting through the sill plate like that would make the wall dangerous. I guess if it's been standing this long...
Replies: 3
Views: 3,619
Posted By bigbucky

How to vent dryer duct through top plate

I am planning to remodel the 2x4 wall in my garage/laundry room to 2x6 so I can put in a washer drain. The dryer duct could fit in that wall but it would have to go up into the attic and vent out...
11-05-14, 09:59 PM
Replies: 4
Views: 3,417
Posted By bigbucky

Sill plate cut through for DWV drain

I removed the drywall in my garage to look at putting in a drain for the washing machine. Looks like they completely cut through the sill plate to put in the drain and water lines. Not good! What...
Showing results 1 to 12 of 12


 
Forum Jump