Waterboss 900 not draining with new parts
#1
Waterboss 900 not draining with new parts
I got lucky and Home Depot had a new (old) unit in storage. It had been a display model and a few pieces were missing including the computer. They were about to scrap it and they let me buy it for parts for $30.
I got the bypass assembly, as mine had a rubber o-ring preventing it from closing.
I replaced my piston even though I am not sure mine was broke. And all new rings.
I switched out the brine valve assembly.
I still have the same problem I had before. I do not get water flowing out of hose. My brine tank fills with water slowly overnight.
So I ordered a new injector kit. Now almost all parts that could be exchanged have been and I still have no water syphoning out.
What else could it be? What else should I look for?
Thanks in advance.
I got the bypass assembly, as mine had a rubber o-ring preventing it from closing.
I replaced my piston even though I am not sure mine was broke. And all new rings.
I switched out the brine valve assembly.
I still have the same problem I had before. I do not get water flowing out of hose. My brine tank fills with water slowly overnight.
So I ordered a new injector kit. Now almost all parts that could be exchanged have been and I still have no water syphoning out.
What else could it be? What else should I look for?
Thanks in advance.
#2
OK, I think I found my problem. The float ball seems to stick on bottom unless I wiggle it. Then it will float in water. I cannot find any reason for it to stick.
Any ideas on this?
Any ideas on this?