Hello everyone, I'm building a new home on top of a hill on an old farm. There is an existing well at the bottom of the hill 100' down and 800' away that is no longer in use. I need to know what size well pump I would need to pump the water up to the house. The well is by the old farm house and I plan on pulling power from the farm house. The well is 40' deep. But from the top of the well, I still have to pump the water up the hill to the new site, so that's another 100' of elevation. The new house has 4.5baths. And the supply line is 1.5"s. I haven't measure the diameter of the well, but it's either 6-8"s. 40ft deep. Any thoughts on what size well pump to get? And does the pressure tank belong at the house or at the bottom of the hill in the well house? Thank you for reading!

The sewage ejector pump in my basement has stopped working. There is a full bathroom in the basement and the drain is no longer working. I saw a piggy back switch and tried to plug in the cable directly. The pump works perfectly fine and pulls out all the water. When put back in piggy back, it does not work. I bought a universal floating switch from Home Depot. I need some help in installing it. Attached are pictures of the pump. Can someone help me understand what the steps are to go about with this? I see there are 2 pipes. Which should be removed? From googling, I believe one of them would be vent. Do I need to remove that pipe also or it has to be left in the lid itself? What should I use to remove the other pipe? I have my brother's family visiting me for Christmas and trying to get this in place before that :D And I am new home owner and my questions/responses might be a little naive :D Apologies in advance!! LOL! [ATTACH]43677[/ATTACH][ATTACH]43678[/ATTACH][ATTACH]43679[/ATTACH]